Table of Content :


Abstract: Polypropylene waste was use to prepare liquid fuel by catalytic pyrolysis. The process was carried out with batch reactor at temperature in between 300 O C to 4500 C by using Zeolite, Zinc oxide, Alumina silicate catalyst. The results from catalytic degradation shows yield of liquid fuel in between […]

66 Preparation of Liquid Fuel from Polypropylene Waste Using ...



Abstract: The effect of different equations of state on production well simulation results have been investigated. Concerning considerable application of PIPESIM software in production units in petroleum industry, the available equations of state in this software have been explored and compared in this article. A production well has been simulated using different equations of state and […]

230 Investigation of The Effect of Equations of State ...



Abstract: In this Investigation, photocatalytic process of COD reduction for a real spent caustic wastewater sample(Red Oil),were used with Design of Experiment(DOE)Method. In this Method, Response surface model(RSM) was obtained in the view of a Box-Behnken design (BBD) with four variables as the input factors, i.e. TiO2 loading (g/l), pH, […]

216 Red Oil Wastewater COD Photocatalytic Removal with DOE ...



Abstract: Rock-Eval Pyrolysis and its results are commonly used for determination and interpretation of the characteristics of sedimentary basins. The aim of this study is to examine and compare hydrocarbon generation potential of Gadvan formation by using Rock Eval analysis in 5 wells of the Azadegan oil field. This oil […]

203 Investigation of Hydrocarbon Generation Potential of Gadvan Formation ...



Abstract: Wellhead choke is an instrument which is installed in flow pipes or where the fluid leaves the wellhead, in order to control the flow, prevent well head equipment damage resulted from high pressure, prevent gas and water conning and sand control. Several empirical models were proposed for multiphase flow […]

193 Developing a New Multiphase Model for Choke Function ...



Abstract: One of the most important properties of reservoir fluids is bubble point pressure which helps the reservoir engineer to estimate reservoir oil in place, inflow performance and to design wellhead equipment. In this study, 65 tested data, related to 10 wells located in the one Southwest fields in Iran […]

178 The Exposure of New Estimating Models for Bubble ...



Abstract: Recognition of Subsurface fracture system is of prime importance for developing carbonate hydrocarbon-bearing fields. The purpose of this study was to employ XRMI in order to provide details of fault related fractures characterization. Also faults and fractures were recognized and assessed through analyze raw data by means of special […]

160 Fracture Characterization Utilizing XRMI Tool and Mud Loss ...



Abstract: One of the most important parameters in understanding static modeling of reservoir is having facies and their distribution in the reservoir zone. Since in the most of reservoirs facies distribution directly related to the permeability and porosity variation, therefore having these parameters can gain an estimate of the distribution […]

150 Lithofacies Classification Using Borehole Image Log and Multi ...



Abstract: Pentachlorophenol (PCP) is a very hazardous compound that enters into the environment by industries such as refinery and petrochemical industry.  As its biological degradation is very slow, this use may be caused pollution of soils and groundwater. Here we compare the results obtained by electro-Fenton and Sono-electro-Fenton treatment methods […]

141 Advanced Oxidation of Pentachlorophenol: A Comparison Between Electro-Fenton, ...



Abstract: In this laboratory study thin disc type pure alumina membranes have been prepared by slip casting method. Constant amount of 1,2-dihydroxy-3,5-benzenedisulfonic acid disodium salt (Tiron) at constant suspension concentration and various concentration of polyvinyl alcohol (PVA) solution were examined. Sintering temperature, solid content, PVA content, ball milling time and […]

130 Study About Effect of Binder Addition and Sintering ...



Abstract: This paper discusses the movement of reservoir fluids movement and shows the procedure of using field measurement unit (Slickline Unit) to determine the contacts between the reservoir fluids (oil, gas & water contacts). In reservoir engineering, various tasks are required to be performed; one of these tasks is the […]

119Fluid Contacts Determination and Drive Forces Movement Monitoring in ...



Abstract: In this paper, a sequence stratigraphy and reservoir petrophysical analysis of a single oil well (Well H) has been prepared by using an available core data and wireline logging data with a view to characterizing the reservoir. In addition, petrophysical analysis initiated with lithology identification and lithological panels interpreted […]

107Geological and Petrophysical Evaluation for an Oil Well



Abstract: In this research for the first time, an electrochemical sensor based on the molecularly imprinted polymer (MIP) onto a pencil graphite electrode (PGE) was fabricated and applied for the voltammetric determination of venlafaxine (VF). The polypyrrole (PPy) film was prepared by the cyclic voltammetry (CV). Pyrrole in the presence […]

95Measurement of Venlafaxine Based on Electrochemical Methods Using Pencil ...



Abstract: Corrosion protection of the metal is one the most serious problems that mankind has to face. In order to reduce corrosion impact and increase service life of metallic structures protective coatings are applied. Nano coatings are important due to their unique properties that may lead to new and exciting […]

82Nano Coatings a Solution for Corrosion: A Review



Abstract: A new two-step route for the preparation of nano-scaled magnetic chitosan particles has been developed, different from reported one-step in situ preparation and two-step preparation method of reversed-phase suspension, Triton X-100 reversed-phase water-in-oil microemulsion encapsulation method was employed in coating the pre-prepared Fe3O4 nanoparticles with chitosan. Two model anticancer […]

76Development of Responsive Nanomagnetic for Delivery of Anticancer Drugs



Abstract: Mesoporous-alumina with high specific surface area was successfully synthesized based on precipitation method. The structural and chemical properties were studied by N2 adsorption–desorption, X-ray diffraction (XRD) and scanning electron microscopy-energy dispersive X-ray spectroscopy (SEM-EDS). The mesoporous Al2O3 support had large surface area and high thermal stability. The effect of […]

70Synthesis and Characterization of Mesoporous Alumina with High Surface ...



Abstract: First Schiff base iminopyridine ligand has been prepared by the condensation between primary amine and active carbonyl group, then related complex synthesized in normal hexane solution. The ligand and metal complex have been characterized by elemental analysis, UV, IR, 1H NMR and 13CNMR spectroscopy. The spectroscopic data of metal […]

66Synthesis and Characterization of Novel Organotin Complex with ...



Abstract: The capacity- resistance model is considered as a quick method to simulate the reservoirs. This method does not require the geological model and is made only by injection and production data. In the method, the reservoir is received the injection rate as the input driver. The response to the […]

53Quick Prediction of The Reservoir Production Future Using The ...



Abstract: Cellulose nanofibers showed varied application in filters, medical and composites reinforcement attributed toabundant resources, large specific surface area, biocompatibility and biodegradation. In this study the feasibilityof using wheat bran as a vast product of wheat cultivation to produce cellulose nanofibers was investigated. Extracting cellulose from wheat bran was carried […]

46Alpha-Cellulose Extraction from Wheat Bran for Preparing Cellulose Nanofibers



Abstract: In this article, synthesis of 1-(4-nitrophenyl)-1H-tetrazole from the reaction of 4- (dihydroxyamino) benzonitrile with Sodium azide in different conditions of temperature, with density functional theory method were studied. For this purpose, at first the material contained in the both sides of reaction were geometrically optimized, then the calculation of […]

39Study of Synthesis of 1-(4-nitrophenyl)-1H-tetrazole from The Reaction of ...



Abstract: In this article, synthesis of the á,2,4,6-tetranitrotoluene from the reaction of 2,4,6-trinitrotoluene (TNT) with Fluorotrinitromethane in different conditions of temperature, with density functional theory method were studied. For this purpose, at first the material contained in the both sides of reaction were geometrically optimized, and then the calculation of […]

33The Synthesis of α,2,4,6-tetranitrotoluene from The Reaction of ...



Abstract: Nanocomposite plates are one of the best options for reducing free and forced vibrations. The present study has investigated the forced vibrations of viscoelastic nanocomposite plates based on equations of free motion in a field with external force. This analysis was performed on primary resonance and in the state […]

25Analysis of Forced Vibration of Viscoelastic Nanocomposite Plate Reinforced ...



Abstract: The production of lipophilic bioactive compounds’ nanoparticles, that recently have been received great attentions in researches, led to easy use of these systems in water based food and pharmaceutical formulations and considerable increase in their either chemical stabilities  or bioavailability. In preparation of these nanoparticles, which also known as […]

19Use of Polysaccharide As Stabilizer in Preparation of Organic ...



Abstract: According to research conducted in our research group on the pyridinedicarboxylatefamily due to their various applications, we decided to oxygenate nitrogen of pyridine ring of pyridine-2,5-dicarboxylic acid as N-oxide to investigate synthesis, coordination modes, and structure types of these compounds in view of crystal engineering concepts. In this work, […]

13Synthesis and Characterization of Two New Cademium Complexes ...



Abstract: Nowadays, the physical mixture of two or more polymers to obtain new polymeric compounds with improved performance has become the focus of attention. The polyethylene/polyamide6 blend is widely used in the automotive and packaging industries. The main reason for blending of Polyolefin and Polyamide enhanced the unique properties of […]

5The Effect of Different Methods of Compatibility to Improve ...